Recent content by Boz Mon

  1. B

    FX-1 Tray pad rivets

    Sweet. I ended up cutting 2 slits in a longer river so it kinda starred when I compress it. Seemed to work pretty good Sent from my iPhone using Tapatalk
  2. B

    FX-1 Tray pad rivets

    Anyone know the correct sized rivets for the tray pads? I can’t seem to find any that work. Sent from my iPad using Tapatalk
  3. B

    JETMATE yamaha swap 760

    Also wondering this. Sent from my iPhone using Tapatalk
  4. B

    FX-1 Gas tank strap insert

    The hole that the gas tank strap mounts to inside my hull is stripped and broke away. How do I fix this? This is the one by the back of the tank not up by the water box. Sent from my iPad using Tapatalk
  5. B

    JETMATE yamaha swap 760

    This is cool. I almost did a 701 swap into mine but I figured it would cost a lot more than using a 750. A few things 1. I found out that you can pry out the stock pisser fitting and you can fit a 3/8 line out the stock position. Seems like no one knew this 2. I managed to fit a westcoast...
  6. B

    Engine Kawasaki dual keihins

    Bump Sent from my iPhone using Tapatalk
  7. B

    FX-1 Fx1 cutting out

    Could possibly be plug wires. Sent from my iPhone using Tapatalk
  8. B

    Engine Kawasaki dual keihins

    Bumpy Sent from my iPhone using Tapatalk
  9. B

    Super Jet Opinions on this head

    Righto. That clears up everything. Thanks! Sent from my iPad using Tapatalk
  10. B

    Super Jet Opinions on this head

    Can I run 1 inlet on the factory pipe manifold? Front or back? I can’t figure out a way to make both work with a single line in Sent from my iPhone using Tapatalk
  11. B

    Super Jet Opinions on this head

    So you’re saying use 2 on the head and bring those 2 into the headpipe? Sent from my iPhone using Tapatalk
  12. B

    Super Jet Opinions on this head

    I was gonna go with this method unless I can get away with using just one inlet. Sent from my iPhone using Tapatalk
  13. B

    Super Jet Opinions on this head

    I have single cooling but it’s going in 2 holes on the manifold Sent from my iPhone using Tapatalk
  14. B

    Super Jet Opinions on this head

    Do I even need to use 2 water outs? I was running 1 on the stock head with no issues? If I did run 2, where does the second one go? Directly to a pisser? Sent from my iPhone using Tapatalk
  15. B

    Super Jet Opinions on this head

    I got this protec head and according to protec it should only have 2 water outs. The rear 2 are factory. Would I benefit from using one of the added ones instead of a factory one? Sent from my iPhone using Tapatalk
Top Bottom