Recent content by CARBONX2

  1. CARBONX2

    Freestyle Best way to tighten pole???

    Thanks for all the suggestions, you got my creative juices going. Machine up Alu bushes, pin to pole(I initially loctited them but that didn't last). You can then use a normal SS bolt with two nuts to lock up. Use highest grade loctite but doesn't need activator(so you can get your pole off...
  2. CARBONX2

    Freestyle OEM 760 Impeller in 155 pump?

    Has anybody run an oem 760 impeller in an oem 155 pump in a freestyle ski. Does it work or is an AM impeller necessary?
  3. CARBONX2

    Mikuni SBN fuel dribble

    Haven't seen that before
  4. CARBONX2

    Blaster Blaster 3 - mods for wave jumps?

    Skim step off head, fit 48mm carbs, Hooker impeller and scoopgrate are all you need. 150hp, a few more tweaks and you can have 160hp.
  5. CARBONX2

    GTX2 motor relocation question

    Move back. Use what was the rear threads as the front threads for the engine mounts
  6. CARBONX2

    Mikuni SBN fuel dribble

    You can, then drill hole from the side. Novi used to do that
  7. CARBONX2

    Mikuni SBN fuel dribble

    Not sure which year they came on
  8. CARBONX2

    Boooom ! Back fire !!!! 760 timing

    FW keys will only shear if bolt is loose or the taper of the FW and crankshaft don't match
  9. CARBONX2

    Mikuni SBN fuel dribble

    Jhb I take you are in CT? When you run a 1200 for FW you need as clean as possible carburetion, took a while to figure it out
  10. CARBONX2

    Guy that made chamber with stock manifold?

    I think ProTec
  11. CARBONX2

    Mikuni SBN fuel dribble

    yes
  12. CARBONX2

    Boooom ! Back fire !!!! 760 timing

    Or the MSD could be faulty
  13. CARBONX2

    Mikuni SBN fuel dribble

    A Jetski shopshould have some in their used spares
  14. CARBONX2

    Mikuni SBN fuel dribble

    You need to change them to the ones with offset hole, it must not be directly above check valve. Yamaha XL1200 uses them.
  15. CARBONX2

    Mikuni SBN fuel dribble

    Need to see the other side. 3 valves are too much. Check arm height of N&S
Top Bottom