One of the biggest issue of freeriding in the surf is water flooding into the engine bay when the Blaster is turtled up. This is caused by the 2 OEM breather hoses being to short . And even worse, a lot of these hoses are cut shorter to allow clearance on mod pipes and air boxes . These breathers tubes are important for feeding the motor with plenty of air and in no way should be removed or blocked off. 701IND has done some much needed R&D on this and are stoked to finally fix this issue once and for all and bring a full bolt on kit to the market. Once fitted, you will not have to stress when you see your Blaster floating upside down after being pummel in the surf. Because these AirDown hoses go the bottom, so when inverted they are way above the waterline. If you have a good hood seal , your engine bay will stay dry. The kit includes both top and bottom breather elbows, 4 in total , left and right PVC breather hoses, all mounting hardware and brackets. The fit up is super easy and should take about 30 minutes. Don't put up with this problem any more. Get your bad boy a AirDown system today.
AirDown System
- Thread starter 701dave
- Start date
- Location
- Cruising Around
Very kool, and like you said, much needed.
- Location
- Beach Haven, NJ
Where can I buy this system??
- Location
- Pensacola FL
I like it Dave! Keep turning out the innovative parts!
ItsRixter
SoCal Wav Jumping shiznit
- Location
- Sunny Diego
I wish they had this when I did my B1100 build. I completely relocated my rear air intake (fiberglass and all). This looks way better.
they just need a U.S. distributor to cut on the shipping costs. Great looking Product!!!
they just need a U.S. distributor to cut on the shipping costs. Great looking Product!!!
- Location
- floatn around
Does anyone else make a system like this?
blasterdude
Waiting for the ice to thaw!!!!
- Location
- The Region
What do they call the pieces you attached the hose to? Would like to add them to my Home Depot list so I can pick them up next time I run there. Also, how long are the hoses?
Thanks
15 Dollars at Home Depot. View attachment 349284
Depending on what hose size you use, they are just a 90 degree threaded pvc elbow with a pvc lock ring on the other side. You can change size and placement, and even locations. You can use the stock holes, but you will have to match the size, or make a cover plate for whatever size you want.