Search results

  1. ngerk

    144 Trim nozzle

    SOLD
  2. ngerk

    144 Trim nozzle

    $160
  3. ngerk

    144 Trim nozzle

    $170 shipped
  4. ngerk

    144 Trim nozzle

    Yes
  5. ngerk

    144 Trim nozzle

    I didn’t use it. Fits 144mm pumps.
  6. ngerk

    SOLD Blaster limited chamber

    Sold
  7. ngerk

    SOLD Blaster limited chamber

    B1 limited chamber with u pipe and lord mount. One of the mounting tabs is cracked. $250 plus shipping
  8. ngerk

    144 Trim nozzle

    This is a brand new Protec (+50mm) extended steering nozzle on a 65v reduction nozzle. The steering nozzle has only been mounted but unused. Has a few scratches on it. $160 shipped
  9. ngerk

    Engine power problems

    Ok so we tested the charge coil and pulser coil and they were both in range and almost exact with a known good stator. On the ignition coil, it has new wires and the MSD boots. From what I read, the MSD boots do not have resistors. What would happen if you ran non resistor plugs? The ski...
  10. ngerk

    Dual Dasa 48s

    Price is listed in his post. 900 obo
  11. ngerk

    Engine power problems

    The plugs and boots seem fine but not ruling anything out without confirming first. It has MSD boots that look brand new and has a nice solid click on the plugs.
  12. ngerk

    Engine power problems

    Not exactly. Felt like a rich bog that lasts waaaaay too long.
  13. ngerk

    Engine power problems

    Hey thanks for that. I have the service manual as well but it didn't occur to me to simply test the parts first. I have a spare stator, coil, and CDI but it would obviously be smarter to test his first. The electronics are sort of a mess. All of the stator wire connectors are outside the box...
  14. ngerk

    Engine power problems

    I went through his carbs completely after he did so they have been cleaned twice. He pulled the carbs and tried different jetting just to see if it would change more times then I could count and the problem stayed. To clarify, its not a normal rich bog or lean hesitation. It will literally lug...
  15. ngerk

    New 750 x2 build

    Yeah I have an electric bilge but still have the stock in as well. I think mine will be fine for now. Anything is better then the stock selector and barely going past neutral position haha.
  16. ngerk

    New 750 x2 build

    Maybe so. The trim system I bought is made to work with the set up like it is (pushing) so probably wouldn't work so well. I just trimmed that piece off the inside of the nozzle that sticks out (like a tab) so it could tilt up as much as I wanted it to. I feel like changing the nozzle would...
  17. ngerk

    New 750 x2 build

    Yeah same here. I'm sure it'll be easy to get used to. Hydraulic system would be nice if they weren't so much $$$.
  18. ngerk

    New 750 x2 build

    Thanks so much! I really appreciate it. I don't have to worry about finding a diagram or tracing stuff now; you made it easy. I definitely wanted to shorten the stator wires...they are waaaay too long.
  19. ngerk

    New 750 x2 build

    I figured I'll just cut the spark arrestor box where it needs it and use it for time being but also figured going to cone style would look nicer and be less clutter. If you could give me the rundown on the wires that would be awesome if you already had it all figured out. I haven't attempted...
Top Bottom