Search results

  1. S

    Carb question

    Tried searching this topic but found nothing. How are you guys mounting the throttle cable with a throttle drum installed? Or another way to ask is how do you torque down the bolt on throttle side with a throttle drum installed? Reason I ask is because I have zero room to tighten the bolt now...
  2. S

    Super Jet Advice on next upgrade

    Would appreciate some advice on what upgrade to do next. I've done most of the popular mods. I mainly ride flat water freestyle/freeride. I have an 03 RN with xmetal pole/steering, blowsion lowered hood, 61x/61x single 44 carb, freshly bored to 82 w/pro-x, threw in a low hour OEM crank, ported...
  3. S

    X-Metal Pole Compatibility

    About to buy an X-Metal pole and was wondering if it'll work with an RRP bracket? And can I use a spring on it? Can't stand a stiff pole. Sent from my iPhone using Tapatalk
  4. S

    Super Jet SN -> RN Swap Compatibility

    I'm swapping out everything from my '90 square to a pre '08 hull and wondering what the differences in parts are between the two. Besides midshaft, what else doesn't port over? I recall reading somewhere the steering cable is longer on a roundie. Is this true? Or is that just for '08+? Trying...
  5. S

    Rough season

    First a rod bearing gave out on my crank and destroyed my top end. Either a needle bearing made its way up the cylinder or there was a ghastly air leak somewhere. So I spent the next 2 weeks of perfect weather out of commission doing a full rebuild. Finally get back on the water and just after I...
  6. S

    Solas Concord 13/17

    What are your thoughts on this prop/pitch? Good for low end snap? I'm running this on my ski and can't really say whether it's been living up to my expectations since I haven't tried out many other freestyle type impellers. I mainly ride flat water freestyle. Got a 61x ported top/bottom with 1...
  7. S

    Super Jet Hull worth

    How much would you guys pay for a freshly painted w/graphics 96 rn hull and hood with footholds and new turf? Looks super clean. Sent from my iPhone using Tapatalk
  8. S

    Super Jet Engine Break-in Oil - Synthetic vs Mineral

    So I recently did a full rebuild with new low hour OEM crank, crank seals, all new gaskets, pistons and new (bought used) ADA head with 35cc domes. I've been reading up a lot on how to break it in but not much talk on whether to use mineral or synthetic and whether it applies to my case. Reason...
  9. S

    Super Jet Flywheel friction

    I replaced a broken stator plate and swapped out coils from old plate but after installing flywheel, it catches on something which I'm thinking are the magnets on the stator. I made sure the woodruff key was in place too. If I turn the crank hard enough it'll break free so my question is.. can I...
  10. S

    Super Jet Water cooling routes

    Hey guys I know this topic has been discussed many times before regarding FP's but I have a pretty rare PSI pipe and want to verify my lines are routed correctly for single cooling. From pump -> manifold Head -> bottom head pipe Top head pipe T'd off straight to pisser and 90° to stinger...
  11. S

    Super Jet Advice on next upgrade..

    My current setup: - 93 SN 701 61x/61x - Ported top and bottom end - Recently rebuilt w/1mm oversize piston - All new gaskets - PSI pipe - One way valve - Reenforced engine comp - 11/16 Hooker - Riva F/A - Protec intake grate - R&D Ocean Pro ride plate (d-cut) - Electric bilge - Footholds and...
  12. S

    Engine Runs, No Forward Propulsion

    Hey guys, bought a new ski the other day but I'm having this weird issue where it doesn't want to move when given gas. It'll fire right up and Idle perfectly fine in water and moves while idling.. until applying a small amount of throttle when trying to idle out which then forward propulsion...
  13. S

    Good price?

    Does this look like a good buy for the price? He had it posted at 4200 less than a week ago.. http://detroit.craigslist.org/mcb/boa/5715558968.html
  14. S

    South East Michigan

    Any riders out in the Detroit metro area? I'm in the Walled Lake/Wixom area and seldom see stand up riders :(
  15. S

    Which mods to get? - 650 Superjet

    I have a 93 SN and I'm looking for more low end power to be able to get a higher launch off my setup wakes and was wondering what affordable upgrades might get me that extra HP I'm looking for? I'm leaning towards possibly a pipe and/or impeller (OEM /aftermarket). Is it even worth spending the...
  16. S

    Flush hose adapter

    I have a 93 Superjet 650 stock and was wondering if there's an inlet somewhere to hook up a hose. Do I need to buy an adapter or flush kit?
  17. S

    93 SN Bogging

    Sup guys! Finally part of the stand up ski family. Bought my first 93 Superjet a few days ago and really excited to get into it! So my ski is bone stock and actually pretty clean from the looks of things. I took it out to the lake the other day and after 5 min or so it bogged down. Couldn't get...
Top Bottom