I just have the one (good) router. if you only want one or two single range extenders for a couple spots its not that big of a deal just to pickup a couple 20-40$ extenders. they are pretty easy setup these days
get the bondo fiber glass filler. I used that on my 91 SN nose piece to fill all the gouges and pitted spots. then sand, prime,clear....
as long as its not needing fiberglass reinforcement this is what i used...
I would just go to home depot and pick up some 320 grit sand paper, rattle can primer white, and clear coat. Tape off the area sand it good and then a couple coats of primer and then like 3 coats of clear if it chips or something just lightly sand and spray the spot again whenever your out of...
I was about to ask the same thing, and is this recommended over the HD purple foam? I have a bunch of HD foam already in my basement from doing my walls down there so I was just going to use that but Beer pong balls seem easier...
Use heat and a sledge and just whack it really hard.....your on a mission now. For your children and your children's children....you will get it apart and you will take pictures for us....
Did George Washington (aka Lincoln) just give up getting rid of slavery because people wanted slaves...NO...
Sounds like a weird one. My guess would be some sort of grounding issue. I would pull out my multi-meter and unhook the starter. Test voltage on the out end of the starter button when pressed the first time, press again and see if you get same voltage out or if there is no voltage, if you have a...
The foam sticks very hard to the side walls, If that foam shrinks inside from slowly melting in the sun the walls themselves are very flexible and will just suck in with the foam. I just cut up my tray a few weeks ago and the side walls are like a floppy noodle when by themselves with no...
Yea, they are in pretty bad shape but they look like survivors...I expect I'll break at least one this summer given all the upgrades so I'll just replace the whole set when it happens.
Going along with this I keep seeing these kenny keepers things....Any reason to get these if I'm just starting out on small surf tricks...no 15' ocean action here.
Resurrecting an old thread for new advice. Anyone have recent recommendations for Motor mounts? In the middle of my rebuild and the 4 OEMs i have on mine look like they are original from 91...I expect I will be breaking them this summer since I'm putting in a...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.