Blaster Aftermarket Bars

Just got a set of protaper bars for the blaster and had a question about the start/stop switch. The stock bars have a hole where the nub fits in to stop it from spinning. Did you guys drill a hole in your bars for this or what is the solution?
 
I drilled a hole, first i filled the start/stop switch with dielectric grease, pressed it to the bars where i wanted it mounted and the grease left a spot where the nub is, that's where i drilled.
 
Location
iowa
Drill a small hole it’s not difficult, better this way. Keeps the kill switch from spinning on bars. Remember the lanyard is pulling on that switch. DRILL THE HOLE
 
Top Bottom