PRO-TEC top end kit

waxhead

wannabe backflipper
Joined
Jan 15, 2006
Likes
690
Location
gold coast
#2
Damn I want this so bad. Im doing a protec replica ski and im using a riva/lamey cylinder with a mach 2 pipe and protec head intake manifold etc.
This would make it awesome
 
Last edited:

Jr.

Standing Tall
Staff member
Joined
Jan 13, 2006
Likes
828
Location
Hot-Lanta
#5
FYI, This Cyl is in Mint condition, Plus its one of the good ones! GLWS!


Ski Ya, Paul
 
Joined
Dec 22, 2006
Likes
121
Location
MotorCity
#7
Lamey cast a few cylinders with the multi exhaust port too. There was a new casting with the three holes a few years ago on this site. That would be the holy grail cylinder of the 62T platform.

I'm sure the protect tooling is still in existence and probably in decent shape since they probably casted less than 50? 100? of these.
 

yamanube

__.|:.__.|:.__.|:._
Staff member
Site Supporter
Vendor Account
Joined
Jun 22, 2006
Likes
2,291
Location
55025
#9
These run awesome, had one at stock stroke that the next owner put an HPE striker kit in, very good in both setups.
 
Joined
Feb 26, 2017
Likes
88
Location
Minnesota
#10
Damn I want this so bad. Im doing a protec replica ski and im using a riva/lamey cylinder with a mach 2 pipe and protec head intake manifold etc.
This would make it awesome

Selfishly, I think you should buy this cylinder and post details of that build somewhere just because I think it sounds cool.
 

waxhead

wannabe backflipper
Joined
Jan 15, 2006
Likes
690
Location
gold coast
#11
Lamey cast a few cylinders with the multi exhaust port too. There was a new casting with the three holes a few years ago on this site. That would be the holy grail cylinder of the 62T platform.

I'm sure the protect tooling is still in existence and probably in decent shape since they probably casted less than 50? 100? of these.
They don't have the tooling anymore. I have asked Carl about that.
Ultimately I think the rival I'll make awesome power I just wanted a protec to go with my build
 
Top Bottom