X-2 Lever actuated trim ideas pleezze ?

Joined
Apr 21, 2008
Likes
128
Location
Canberra, Australia.
#2
Seeing as all the hard stuff (trim nozzle/trim cable) has already been done at the factory, it strikes me that some sort of (hand) lever and cable connected to the existing position selector would be the way to go.
 
Joined
Jan 30, 2019
Likes
1
Location
Eden nc
#3
Seeing as all the hard stuff (trim nozzle/trim cable) has already been done at the factory, it strikes me that some sort of (hand) lever and cable connected to the existing position selector would be the way to go.
I just set mine up with up trim for freestyle on a lever if you still need info
 
Joined
Jan 30, 2019
Likes
1
Location
Eden nc
#5
I used a clutch lever from a atv and a throttle cable from a Yamaha wave venture and my ski already had a tube in the right side and I flipped the trim nozel over and ground it out so it has more movement and made a bracket for the cable to pull against or mount to it's pritty simple
 

mike b

Michael "Mayhem" Bevacqua aka MikeyChan
Joined
Sep 3, 2012
Likes
1,024
Location
California
#8
My buddy used the cats trim cable and lever off a yamaha onto his. He has it set up for positive and negative trim I believe
 
Joined
Jan 30, 2019
Likes
1
Location
Eden nc
#9
That could work too but I don't think you would get as much movement up I'm going to eventually try to flat water flip mine once I get the 1100 motor in and 148 pump so I set it up for as much up trim as possible
 
Top Bottom