X-Metal Scupper - Need New Rubber?

motojunkie96

AKA "The Paulinator"
Just got a used X-metal scupper and the actual scupper "flap" is starting to crack in areas. Does x-metal sell replacements (I looked at the website but didn't see anything) Or does anybody have an alternate solution? Yes, I'm aware that all I need to do is cut a new piece of rubber, just thought I'd see if anybody has found anything that works better than another material.
 
Last edited:

mosquini

Looking for a fixed steer standup
Location
Mendocino Ca
Send a pm to pat (IKSTEJ) , he is a standup guy who will hook you up with the rubber or point you in the right direction.
 
We just installed a couple X-metal scupper valves and no leaking yet. I was very surprise but the new flapper works great.

How new?

Newer then this one?

13_large5.jpg
 
I have the old style polished flap support, with the X logo cutout, as well as the style shown above. I dont see how this one would work any better?

Only dif that i can see, is that its thicker, has a third screw to secure it to the bottom of the flap, and the screws are recessed.
 
Nice man, I emailed them this morning and had a response within minutes, dirt cheap as you said. Thanks for chiming in and please get Joe Gallagher back on his Superjet
i barely talked him out of selling it a few years ago.
I had to tell him it was a POS and he wasn't going to get much for it.
I haven't been able to talk him into riding it.
I called him before the Pismo rides for years now and he never goes.
I think he got old and fat on us
 
Top Bottom