Rushford_Ripper
Site Supporter
- Location
- New York
Is there any way to install a pisser on a completely stock 650 squarenose? I want to be sure the engine is cooling!
Super Jet 650 squarenose pisser?
- Thread starter Rushford_Ripper
- Start date
Mike W
Infidel
- Location
- North Florida
Yes. Just T into the line going from the top of the head to the pipe. It will dry out the pipe slightly so it will give you a little more performance.
Rushford_Ripper
Site Supporter
- Location
- New York
That is a really small line but thank you for the info, I will be doing that!
- Location
- Ahwahnee, CA
I would T off of the line going from the cooling line fitting on the back of the head to the bottom of the pipe/ manifold.
Rushford_Ripper
Site Supporter
- Location
- New York
That would make more sense, thank you!
Mike W
Infidel
- Location
- North Florida
That is what I meant. I assumed it was self explanatory you would T into the line in the back of the head.
Rushford_Ripper
Site Supporter
- Location
- New York
I'm sorry, I thought you meant the real small almost primer line in the cylinder head on the stator side.
- Location
- Tempe, AZ
i literallty blocked off the small cooling line on the head, routed the small hose from that exhaust nipple out a pisser and then the main cooling line "t" to another bypass. only at wide open throttle will the small line spurt water but thats telling you when your wide open its drying the stinger out a bit. i rode mine like that for 6 months till i found a 701 wr3 for $700 on a trailer i gave the guy $425 titles for all.