Search results

  1. Z

    RRP pole carbon chin pads

    Got mine today and it is beautiful! Pictures don't do it any justice. Super impressed. These should sell out in 5 minutes on here.
  2. Z

    Just wondering if you sold that oem 155 pump and wear ring?

    Just wondering if you sold that oem 155 pump and wear ring?
  3. Z

    What's your view look like today?

    The hard work is done!
  4. Z

    2015 superjet slow cranking

    I had a starter issue I fought for quite a while (batteries, charging, jumping, etc) turned out after taking it apart and REALLY inspecting the shaft with all the windings there was one wire that had broken. I felt I was fighting the same issues you described. Finally bit the bullet, got a...
  5. Z

    Do you still have that trim gear? Can you tell if the upper arm can be rotated (for a superjet...

    Do you still have that trim gear? Can you tell if the upper arm can be rotated (for a superjet pump)? Also what would be your paypal price shipped to: Steve Zacher 6010 Crestline Dr. Manhattan, MT 59741 406-580-6919 Thanks SEZ
  6. Z

    Thrust ez drain issue

    I don't, but the old one would almost go thru the hole and you could barely touch it with your finger when it was stuck. The new one barely fits in the cavity when you put the grate on. If it's sitting just right on the stand in the water, and it's draining a little, it'll vibrate open and...
  7. Z

    Thrust ez drain issue

    Had this problem this summer. My ball seemed smaller than the picture on the TI website. They have the bigger ball for ~$7.50. Haven't had an issue since.
  8. Z

    Super Jet help please before surf slam

    3/8 in from OEM on hs needles. Oh and this was a '95 sn. 5000' elevation shows ~ 94% jet reduction on the mikuni pocket tuner. Worked for me on the main jet...not the pilot though. Left that at sea level stock after trying all three sizes down to 62.5. 67.5 had a slight lean hesitation but...
  9. Z

    Super Jet help please before surf slam

    Not much elevation info here. I had a lot of trial and error to get my setup right at ~5000 ft. I have stock 62t 701 with dual 38's in a 95 an. Ended up with the stock pilot (70) but went from 130 to 122.5 mains. Set idle at OEM (7/8 I think). I'm about 3/8 turn in on hs needles and haven't...
  10. Z

    Super Jet SUDDEN loss of power - info posted below

    Got check valve yesterday. Put it on and it worked! Yay. Case closed.
  11. Z

    Super Jet SUDDEN loss of power - info posted below

    Thanks guys. I'll try both of those. I've done the visible exhaust leak check. Nothing noticeable. Hard part is it'll run on land but you have to load the pump to really find out if you've fixed it. Water isn't too close by so it's a pain diagnosing.
  12. Z

    Super Jet SUDDEN loss of power - info posted below

    Still waiting for some suggestions.
  13. Z

    Super Jet SUDDEN loss of power - info posted below

    I have a 1996 Superjet that is completely stock. Playing around in water,I did a submerge, came up, made a high speed run for 15 seconds, turned and vhwoomph jetski acts like I lost a cylinder. I am able to idle it back to shore and back to the trailer, and it acts like if I give it a little...
  14. Z

    Chris Fiore - Talk about awesome service!

    Been stalking for a while but I would make an account just to post this. Sent from my DROIDX using Tapatalk 2
  15. Z

    Chris Fiore - Talk about awesome service!

    I had an electrical issue through the July 4th holiday, and contacted Chris. He replied back almost immediately (remember this is a holiday), and sent me the part first thing. His communication was top notch, as well. Also, after receiving the part, Chris has been stellar in giving me advice...
Top Bottom