Freestyle building a MICRO ned input on pipes that will fit

[madscientist]

i am building a micro and have a wdk 1200 on the bench to use. the motor itself will fit but the pipe will not. what are my options to put the 1200 in this hull?

the tnt chamber on a lamey fits great.

 

[madscientist]

i am building a micro and have a wdk 1200 on the bench to use. the motor itself will fit but the pipe will not. what are my options to put the 1200 in this hull?

the tnt chamber on a lamey fits great.

 

[Ducky]

Is that 1200 based on the 66e cylinders? What manifolds will fit it?

 

[madscientist]

yes 66e based. i could do an adapter and run the tnt pipe.

 

[Ducky]

yes 66e based. i could do an adapter and run the tnt pipe.

Yea or a SJ mod chamber. I dont think you have too many other options. How much does the WDK pipe not fit by?

 

[madscientist]

Yea or a SJ mod chamber. I dont think you have too many other options. How much does the WDK pipe not fit by?

7 inches or better

 

[yamanube]

Unless it is much wider than a superjet inside you won't fit a B pipe headpipe/mani with an adapter plate on the 66E. I think guys are running the powerfactor pipe in Micros, might be able to get that to work with a custom manifold. Either way, I highly doubt there is a bolt on solution.

 

[madscientist]

the narrowest part of the hull just below the hood is 2" wider than the sj.

 

[N3vrSat1sfied]

Can you move that engine back? That would give you a lot more room. My aerial only has two inches between rear hood seal and rear cylinder


Sent from my iPad using Tapatalk

 

[madscientist]

About 3 inches when I get the gp800 mid shaft.

 

[N3vrSat1sfied]

Did you try an old style pfp? Check my aerial build. I know it's not the same but it went together like butter!


Sent from my iPad using Tapatalk

 

[madscientist]

Did you try an old style pfp? Check my aerial build. I know it's not the same but it went together like butter!


Sent from my iPad using Tapatalk

Not yet. Just know the wdk wont fit.

 

[N3vrSat1sfied]

Get it figured out?


Sent from my iPad using Tapatalk

 

[madscientist]

Not yet. Have had time to play with it

 

[EvanKrefski]

I have a power Factor slammed in mine but it is a 62T based motor.