Proformance1
Liquid Insanity
- Location
- New York Crew
Cant wait to ride this thing again at the freeride. Very nice ride
Djkorn1's Trinity EVO Freeride Build
- Thread starter djkorn1
- Start date
- Location
- Cleveland Ohio
Epic FAIL on the footstrap. Back to the drawing board. I guess I needed to scuff it up...hee hee. :crying: I am going to glass it down a foot around it. If that doesn't work, I'll fire stainless screws in with 5200 on them and then glass around them.
Zach, you can ride it tomorrow. :wave:
Zach, you can ride it tomorrow. :wave:
Attachments
spork
down with the sickness
- Location
- Indianapolis Indiana
Should've warned you that polyester resin won't bond to epoxy resin (which i'm assuming is what your hull was made with).
spork
down with the sickness
- Location
- Indianapolis Indiana
Hey stranger!
SuziQ
Banned
- Location
- an hour or so away
Last edited by a moderator:
- Location
- Cleveland Ohio
Uh oh...I just did it again...This time I actually sanded off the turf padding and turf glue
I also scuffed it up really good and glassed an area 14 times bigger than last time. I hope it sticks to the gel coat or whatever is on the outside of my hull. I'll find out tomorrow when I'm riding. Trial and error...Attachments
Last edited:
- Location
- Cleveland Ohio
- Location
- Cleveland Ohio
- Location
- Virginia Beach, VA
Reviving an old thread! DJ, I have a Bruins steering plate on my new SJ build. Do you know where I can find more info on it? I'm hoping to run Phat Risers with it.
schicks
Karma Enforcer
- Location
- West Michigan
i just bought a ski with a bruins turn plate and bars! Wonder how many of those he made? Its a nice setup. I have not removed it yet, but it looks like the turn plate works with straight mount bars, not sure on the diameter yet...looks like they will work with fat bars though.
