Eds RN Stroker SJ

E

Ed3SJ

Location
SW Florida (Ft Myers)
Finally got a ski after selling my last SJ over 2 years ago.. felt good to finally ride again after 2 years of no riding at all. Some of you probably saw my post asking your oppinions on the ski... well i decided it was in my best interest to purchase it. I got it last week and got a 30 min ride into it before it had some ignition problems (which is now fixed) Heres is a list of everything it has that i know of.. im sure theres more in there somewhere..

Engine:

• 5 mil ABLE Freestyle stroker motor
• MSD Total loss ignition
• 46mm. Carbs
* Able Cylinder
• Able Head
* Factory B Pipe Mod
• Internal fuel pump
• K&N Air filters
• Billet UMI Drive Shaft Coupler
• Carbon Tech Reeds

Hull & Body:

• Reinforced
• X-Metal Pole -4
• X-Metal Turn Plate -2 with 0-degree bars
• X-Metal Bracket
• X-Metal Water Box, with Side Exhaust
• X-metal Hood Latch, and Hood Hooks
• X-Metal Scupper Valve
• Water Craft Lowered Factory Hood and Nose Piece
• WCF Chin Pad
• WCF Footholds
• Hood Straps
• UMI Finger Throttle
• ODI Grips
• ProTec Freestyle Trim (complete system)
• Blowsion Bulge Bracket
• Two 500 GPM Bulges w/ On/Off Bulge Switch (on handle bars)
• Side Rail Extensions
• Custom Pant Job.

PUMP:
• Freestyle Cone
• 13/16 Skat Track, 3mm. Cut back
• Stock Ride Plate
• Worx Intake Grate


img0192wu1.jpg


img0194fp1.jpg


cb5f12uk1.jpg


img0226zh0.jpg
 
You must log in or register to reply here.
Top Bottom