Team CRAMMIT C/F HULL !!!

Status
Not open for further replies.
GIL

GIL

Power In The Hands Of Few
Location
Cullman AL
mcdog said:
Team Crammit screwed me over on a pipe chamber 5 years ago. I saw one in GIL's hull in the pics. That stung a bit. I'm still waiting for mine. Joke.
Click to expand...

Everyone knows his chambers lose power after a 15 minute heat soak! Why would I run one of those?
 
GIL

GIL

Power In The Hands Of Few
Location
Cullman AL
sjetrider said:
And you are the PR guy? LOL!!! NICE MOVE!
Click to expand...

No, we hired Mark Erricson to be our PR guy and handle getting deposits on all pre-orders. We are trying to get the state of NJ to allow him to have a phone so we can post up a # for contact. Call time will be very limited due to the fact that they will only allow phone privileges during visiting hours.
 
GIL

GIL

Power In The Hands Of Few
Location
Cullman AL
Matt_E said:
Will you be offering a pole bracket?
Click to expand...

No. But you will be able to utilize ANY pole bracket you desire!!! The one we tested with today was off of a 3d and was decent. We were getting some nasty flatwater flips without a setup wake and running a 300sx engine with a 195mm MAG pump.
 
GIL

GIL

Power In The Hands Of Few
Location
Cullman AL
Scorn800 said:
Can I get it in visual carbon with black and green weave?
Click to expand...

Of course you can!!! We would be honored for you to be one of our top racers!!! You are close by, go visit Mark Erricson tomorrow during visitation and give him a deposit. After the deposit is made we should start production on your new hull sometime. You will love it-it WILL be the best ever!!! I just talked to crammit and we are going to make a new dry pipe that will work for racers and freestylers alike!!!
 
Last edited:
Status
Not open for further replies.
Top Bottom