Recent content by Eli760

Ended up going internal fill.

Looking for a square nose fuel neck or what what hose configuration works. Thanks in advance.

Looking for some rrp coupler spacers or similar. Think they are out of stock currently.

Mine only goes up to mine only goes up to 6inches 152mm

Is feeeler a bad word when spelling with 2 e’s

Good question I’ll measure tomorrow once I figure how. Might have to get a circumference and do math or put in pump and use feeler gauges And subtract from pump diameter. 161. something is my guess tonight

I ran a 1200eme think the previous owner ran a 1200 dasa.

Sold 162 xscream oring style pump 1000$ Two impellers 275$ each or 500$ for both. One is a 6/15 I’ll get specs for other with pictures Thrust 155 trim with bored reduction and steering nozzles 500$ without trim lever 525$ with. Or 2000$ Shipped for everything No drive shaft/bearings/seals

Looking for 2 eme1200 domes. Either 36cc or the high compression ones. Thanks in advance.

Found thank you guys

Looking for an xmetal comp length pole Could use bare pole or complete. Don’t need hull bracket. Seeing if any one has a used before buying new

I’m looking for a round nose fuel fill neck and a stock exhaust to waterbox hose.

650 flywheel and pick plate and mounting plate. 200$ shipped obo

Montana to Arizona and a few places in between. Only snowed a little

Is pump still available?