Search results

WB starts & idles fine. The low end is fine, but as soon as i get to high speed it stalls. Sometimes it is difficult to start immediately after it stalls. it seems like its loading up, but not sure. I have taken the single carb apart & rebuilt, with no difference. Please help.....

i'm going to clean both carbs & see how they run after that. if i still have issues, i'm thinking of turning the high speed screws in 1/4 turn. Are you still selling the tubbies & hood for an x2? Thanks for your help & ideas. very much appreciated.

I have high speed "bogging out" issues w/ two seperate blasters. - single carb ski completely dies @ full throttle. -dual carb ski bogs out @ high speed. i have not cleaned out the carbs yet. i have not seen any water in the gas or lines. I'm assuming the carbs need to be taken apart &...

I have high speed "bogging out" issues w/ two seperate blasters. - single carb ski completely dies @ full throttle. -dual carb ski bogs out @ high speed. i have not cleaned out the carbs yet. i have not seen any water in the gas or lines. I'm assuming the carbs need to be taken apart &...

Using aftermarket flame arresters on 2 wave blaster, & continue to take on to much water when in the surf. Should i go back to OEM ? i'm assuming this is a common problem when using the pre-filters & after market arresters. any ideas? thanks!!

thanks for your ideas. After fooling w/ the low speed adjustment on both carbs, it ran perfect. i guess after cleaning the carbs, it needed an adjustment to compensate for any debris, etc. Again, thank you very much for your help.

I have a 96 dual carb wb1 that is not running well @ low speed or idle. I did have water in the fuel last week, but i drained the fuel, cleared the lines, & installed a carb rebuild kit. I started it today & it idled high. when i put it in the water it would bog down as soon as i hit the...