Search results

Looking at geetibg one but want some suggestions ig I’ve got a wb1 that just blew the motor it’s already got tons of work too it and would be running a riva red pipe jet maniac water box riva aftermarket cdi and 46mm single carb and I want it to be a nuts surf ski with a 10/16 prop what would...

Yes I did

Also my buddie said it reminds him of how his sled ran with a bad crank seal even tho these should be new but funny thing about the crack seal is the carb this motor came off of had a red pipe on it and mild mods hence why I thought it would be a good fit and that motor when I took it apart the...

Can’t I do a leak down as well if I do a compression test and watch the gauge and how fast it drop or anything or no sorry I’m new to the leak down game

Ok thank you

What’s the best way to do a leak down test?

Hey so I took my b1 out tonight and it revs and hits limter etc fine outta the water but in the water it run great for like Mabye a minute and flooring it once but then just breaks up and runs like poop it has a riva after market cdi has riva red pipe Ada head with 35cc domes brand new built...

I do plan on pump swapping it and trying to put trim on it and I definitely think it will need help over a wave but I am going to try my hardest

So I have a goal of doing a backflip on my wave jammer lol here’s how it’s going I’ve got a ported 701 61x in it with bumped compression and now I think I got my pipe to fit outta a old project will need a little bump in the hood but surprisingly it fits super well here is some pictures

I am building a b1 for surf with a all new 701 61x with a factory carb i have a riva red pipe and jet manic water box 35cc domes I wanna know what jers to run in the carb it also had a 10/16 prop in it also how should I run the water lines it has 2 pissers in the hull side and two fittings in...

So how much do I mill off? @jpswift1

I am looking to bump compression on my 1100 Yamaha motor I know back in the day and Mabye now people would mill off a couple thousands off the head to bump the compression I am wondering how much I can do to raise power and still run 93 any help would be awesome

working on modifying my wave jammer and people are saying those pipe work if you have any other ideas that would be appreciated

That helps a ton wish I could just look at one outta a ski lol but definitely am gonna try the pvc thing and will get some pictures of what happend to it

Yea even if I knew the measurements on it for the seals and outer tube to clamp too Mabye I could fiberglass a small section of pvc

It does unbolt from the hull but it is also like resined in I believe I’ve taken the bolts out of it and could probably get it out just don’t know where to get another one

the rubber tube that go around the driveshaft has no where to connect to on the bulkhead side I think it got sheared off somehow

I did I looked through every schematic there was and didn’t find it anywhere that’s why I am asking here but I will double check again

Yes it is a 2017 vx1100

I am in search of this like bulkhead for my ski I don’t know what it’s called or where to find it any help would be great thanks