Search results

ISO a msd curve for a dasa 8mm 950. I have timed my superjet 700series for lots of years just wondering what has worked good and safe for you guys.

I now have 3 junk superjet cranks. Two are oem with blowen center bearings and one is sbt welded rebuild that is on its last legs. (Had a very good run). Shipping for the cores seems to cost more than the rebate. Located in Ontario. What do i do with them before they become rifle targets?

I thought I would share with everyone my latest project. I got the hull out of a pack barn from a friend who has had it for quite some time. It appears to be 50's-60's kit boat(judging by the slot brass screws) where you would get a plans book and build it yourself. I want to fix it just to try...

What is available for jet ski totes? Looking a for same style as jet lift but not sure what else is out there. Looking for one that crosses deep sand easily with superjet. Thanks

Hey guys, looking for some info. I doing a rn superjet build from a vxr pro part out. Just wrapping things up and thought the vxr steering cable was same as superjet, turns out it's not, overall length is about a foot short and the pole end throw is different. So ya, I need a sj specific cable...

Does anyone know how to test a all in one CDI+coil on a 550? Thanks.

Hi, has anyone had a problem with their Superjet running on only one cylinder with dual channel MSD total loss? Here's whats happening: It fires up on both cylinders but immediately shuts down to run only on one cylinder. I have eliminated all the problems except 2 I think: 1. My battery is a...

So I've been shopping around on the net looking for a good scoop intake grate for freestyle. Whats your guys opinions on the best one?

why do buckshot carbs produce low fuel signal strength? is it because they have straight cut throats to flow more cfm? help! is there a way to improve signal strength at all, other than restricting air flow?

need a start for jetting....dual 44 mikunis going onto 61x/61x. 701 ported cylinders, boyesen power reeds, 190 psi comp, b-pipe, total loss. 574 ft above sea level. 70 degree f. most of time

I was just wondering if anyone has run the mag pump 75mm hub skat props in a stock pump without a tbm? I need a new prop and want to run the mag pump skat prop and tbm cone eventually just can afford the whole thing right away. I dont wanna take a step in the wrong direction and have to buy more...

Has anyone made their own scoop grate out of a stock one? I realize that most of them are cast and could be difficult to weld although I have had success welding cast before... I was thinking of hammering and piece if 1/4" plate aluminum into a scoop, notching for the the two strips and...

Motors underwraps in the corner for now. Leaving the best part for last!!! did the scupper tonight. used the home depot special and dumped it into the pump area. I'm not reafoaming and the hull was really flexible so I'm cutting off peices of pvc to brace the hull. They will eventually be...