Search results

Might be a lil late but the one way tube is at an awkward angle. i tapped the hourglass in to where the bottom left edge was flush with the back of the hull. the end cap does not snap into the hourglass (must be epoxied in), it does however touch one small area of the hour glass (bottom left...

Can you post a pic

Looking for a 62t or a 61x FP exhaust manifold

i'll take the sbn adapters.

found very little info so i made a post for my 2015 xfs Ti ez drain install. http://www.x-h2o.com/index.php?threads/thrust-ez-drain-install-2015-rickter-xfs.191118/

check repeatedly with the end cap and tap the hourglass in until the cap sits flush to the hull. there will be noticeable gap on the pump side. with the end cap sitting flush to the hull you can now mix up your epoxy to permanently install the end cap. I used G-flex 2 part epoxy with a little...

2015 xfs glass Rickter scupper started either sticking shut or would stay open and about sank a few times on the lake. decided to purchase Thrust Innovations EZ drain 2-3/4". first step is to remove the old scupper remove the three allen bolts I applied some heat to the scupper ring to...

plexus or devcon 2 part epoxy. i used some black pigment mixed in to match the hull.

3 UFO mounts from Jet Maniac epoxied on using a cold fusion ebox bracket is what i run. could probly get away with 2 of thier big mounts and mount the ebox directly to them.

I’ve seen an 2017 Xfs hood pop on a failed back flip and it sank to the bottom of the river. Walked away with the hood and tank. We all now run hood straps. Worth the extra insurance.

I did what dmpus is talking about. Put the mid shaft in the press and moved it towards the engine a couple Mills.

You can use UFO mounts with cold fusion bracket

How are you guys mounting a bilge bracket, my 2015 xfs midshaft housing doesn't line up like a superjet so Blowsion mount is out.

Had a convo with tom at hot products. I was told dasa prety much took over the design. Butterfly's are part #BN48BF I didn't get to ask about the shaft.

Did you have to modify them at all?

can't find any info. Know something about the angle is custom and they most likely have to be massaged into place. I see hot products used to sell a kit. Really just need new brass butterfly's.

Exactly! Lol

So once again I broke the stem or stud as you would call it, almost loosing the krok collar into the abyss. Bars were not previously loose and bearing is nice and tight or should say rolls smooth with no play. This system is outdated now but they continue to sell this piece of $hit steering...

Looking to purchase a xfr. Are there any differences between the 2013 and 2014 model? I know the graphics are dif.

What do you think about the needle and seat sizes being different? think