Search results

Hurray! Lots of fiddling and poking around in main outlet hole with picks but in the end a reluctant resort to carefully 'dremeling' the bit from the screw hole did the trick. I used a diamond coated cone bit with same angle and size as the needle head. In the attached picture it has lost its...

Would anyone have experience getting the adjust needle tip out of the hole? I haven't gone down the path of drilling or anything yet. Thanks

Finally got things sorted. Unless you have professional tools, don't try to expand the pump housing. I instead used a flat sander to carefully sand off the excess from the prop blades. Make sure to mark well how much to be taken off. As a note, when pulling old impeller the...

I got it installed the other day and it was quite a messy job. The hull seems barely strong enough for tightening the screws so I had to use bolts where the thread gave in. Next time I will just remove fuel tank and use more bolts instead. That will also keen the fuel tank from being...

I have a 750 SXI and am scared to snap the tubbie II's if I try to mount it according to the instructions I received with the purchase. This is because the sponsons do not feel to have much flex, probably due to its unique shape. Has anyone done this before successfully and how would the...

The Solas 9/15 impeller that I bought new is up to 1 mm too large in diameter to fit the pump housing. It is advertised to fit my '97 750 SXI (year based on hull id) and I wonder if I should either grind the impeller edges, sandpaper the inside of the pump until it fits or just return it.

Just another fun blast around last weekend in NZ on a Kawasaki SXI 97.