Search results

Looking for a used 155 setback pump and driveshaft. Will be shipping to 19465 , Thanks for reading. Sent from my iPhone using Tapatalk

Still have the chamber? Sent from my SM-A325M using Tapatalk

Looking for a set of 760 electronics for my new motor, Need everything but the stop start switch and the cdi. Thanks

In search of set of dasa48 carbs Sent from my SM-G950U1 using Tapatalk

Lost my rrp trim cable adjuster bolt, goes through the heim joint, any sources for this metric sleeve bolt? looks similar to the raptor adjuster.

I just threw a single channel total loss on my 701, its wired correctly, timing is at 30 degrees, reeds are in good shape, carbs not leaking fuel and its got a nasty backfire while running and while cranking. the led light comes on on the brainbox when you put the s4 switch on to check. can...

pissssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssss NEIN NEIN NEIN NEIN NEIN NEIN NEIN NEIN NEIN NEIN NEIN NEIN NEIN NEIN NEIN...

Any suggestions on jetting a 62t62t with oem 44s powerfactor wet, I'm running 135 mains, 115 pilot. 90 jet in spray bar. 1.5 seats with 95 gram spring. I have a low end hesitation I cannot get rid of. Any ballpark numbers? Thanks in advance

Sorry my phone is retarded

Pictures of hull?

In search of factory b head pipe, already have manifold and chamber, shipping to 19465. Thanks in advance. Woookie

Asking for a friend, anyone have a complete wb1 seat?

I definitely messed that up. I re ran the hoses, going to take the ski out tommorow, Thanks for the helpful response. Hopefully that was the cause of the bogging, because it ran great with the stock exhaust.

I think have found my bogging issue, too much water in the exhaust, Do i have the lines hooked up correctly? The line off of the pump goes into exhaust manifold, i have a tee off of the head one line running to the fitting on the headpipe near the bolts, one running to back of pipe and a line...

Ive got an 88 650sx, just threw a team butch pipe and water box on it, I am dealing with a bogging/loading up issue with my ski, it runs great for about 20 minutes or so, then it boggs like piss and wont get on plane, take it out of the water and run it and its good for another 20 minutes...