Search results

Pm sent

It was probably just badluck

Just buy whatever is sold in the gas station when getting fuel, so you know they are compatible…

Carpeted 2x4 on edge spaced 12” on center works good for sj and most 2stroke stand ups. Not required but you can router the edges of the board a bit to get longer life out of the carpet. Composite / recycled plastic board works too but depending on the trailer frame setup might need additional...

But does it include a front tigercraft badge?

Pm sent I’ll take the trim / non trim and head.

Pm sent

I have the same issue with some old bmr/ F/S “47”s and got the same response on parts lol. It looks like the shaft is just the original 46 with the slot widened and screws original mikuni too. I would assume yours will be the same. Not sure yet where to get the butterfly tho.

Another possibility, an overlooked bent rod could cause uneven compression. If you didn’t, check squish clearance w lead before pulling the head, would be an easy check.

Pm sent

Mine sticks too. I’ve tried cleaning, silicone spray, and a new / “updated” larger ball. It’s better than it was but still sticks regularly. Interested if anyone has a real fix!

You measured a constant draw with an amp meter? I get a spark when first hooking up the battery ground on mine, but it doesn’t drain the battery if left connected.

Having a charged battery is definitely a good first step…. Do you have the programmer? You can see cranking rpm on there as well as do a spark test.

As far as I know, this is basically the same as rrp x-lite steering. On my rrp x lite, i was having trouble with it coming loose when new too. On the base where the center bolt threads in, there is a stainless “insert” that has left hand threads on the outside. This was coming loose causing...

I very likely had the lanyard (surf switch) engaged and usually do from clearing it out on the trailer. I can’t remember if I had the battery ground hooked up after Daytona, but it might of been. I cleared out more potting- I’m getting 5v on pin 4 without the programmer hooked up. The part I...

Guess so lol https://www.x-h2o.com/threads/760-electronics-with-zeel-and-flywheels.204158/

He did a good job with the ad descriptions too, must have found them somewhere else and copied them.

I did some “digging” in mine lol. Where it had the hole in the potting looks like it could be a “linear voltage regulator” with a heat sink. So makes sense that if that burned up it would have these results like you explained. Not sure how to test it but maybe I’ll try to replace it…...

Are you trying to say ur not shipping it out Wednesday?? Lol

I am, however once I determined that I had spark while the programmer was plugged in, I removed the extension and had the same results.