Search results

what size reduction nozzle are you running?

I got a oem rebuilt starter from JM I should install to replace my chinese one with and the skiis running. Still got to get the camper ready. We are camping mon-friday at ddrr.

It was a couple years ago but if i remember correctly it was the thickness of each vein needed to be widened slightly. Also the bore at the front needed to be a bit larger it think.

No a 144 stuffer is not a direct fit into the 155. About an hour of fitting and grinding little by little with a dremel i was able to fit a 144 tbm into my oem 155 nicely. Its easily done.

I still kicking around Mike.

Huntsville Ontario

yes, that is correct

Hope this helps.

you want the electric start on, it pulls initial timing to allow the machine to start easier. you want S1 on Switch 1 off, you dont want to add 4000rpm to your rev limit. you want your retard +15 switch on, it gives you more options when setting your retard.

I have been running 31.8mm aluminum Easton Monkeybars for 7+ years now with a ovp setup, I like the feel but come from a motocross background, not a sign of damage or being bent.

does not look like bottom end failure to me, bottom end failure ususally leaves sharp dents of all makes and sizes from crank bearing races. does not look like detonation or water ingestion either. to be honest it looks like a small round ball shape of metal got sucked up or possibly a reed screw?

120 pilots, 135 mains. 2.5n/s with 95g spring on my riva powerbombs.

i have dual 48's on my 735, work great for me. if you jet them properly you'll be fine.

Anyone have one?

ISO a msd curve for a dasa 8mm 950. I have timed my superjet 700series for lots of years just wondering what has worked good and safe for you guys.

Single 48 riva powerbomb on a max ported 735 with msd tl and bpipe, 6/12 155 e75 skat. what hull you plan to run? What information are you looking for? Ski is easy to tune and loads of fun, it's as reliable as how much time you put into bulletproofing it.

Skat c75 13/18 on a 735 ported with total loss.

B2 stator section only measures 153mm ID. 96 wave raider 1100 measures 157mm ID. We use WR setups.