mikuni 38

1. So I broke the tip of my needle on my 34mm mikuni was wondering how people got a broken tip out? 2. Had a 38mm mikuni laying around so I threw it on the 300 set high and low at 1.5 turns seemed to run fine but haven’t tested it on the water yet but was wondering if anyone has done this...

I’m just about to finish painting and putting my ski back together, but I need to figure out the carb situation. Jets, springs, new needles and seats possibly. I’m running dual 38s, ada head with 35cc domes, lightened flywheel, solas 144mm 12 vane pump, 9/15 impeller, and a riva red pipe. Let me...

I’m building a wave blaster right now, and I’m running dual mikuni sbn 38s inline, with a protec manifold. There’s one pulse fitting on the manifold, along with what looks like a plug in the rear pulse fitting. Is this the proper way to run this setup or should I have the two pulse fitting...