total loss

its been a long hard decision but i think its time to thin the heard for now. i just don't have time to rid one ski let alone two and get it set up. i was trying to build a Lee stone replica but lack of use this year and no time to tune it properly with short ride seasons on this glacier fed...

Decided to sale my MSD TL system that is still currently installed in my T1 ski. Included in the sale are brain (all three channels work properly) pick up/trigger plate, flywheel, and two coils. I have video of the ski running to demonstrate correct operation and condition of electronics that I...

Have a Jetinetics system for a 650sx that the brain crapped out on. Was told to get a zeeltronics replacement but can't figure which model works best. Was looking at the a02t but not sure if it will work with my pickup. (3 wire hall effect sensor, uses the 2 magnets on flywheel). Anyone have...

New member here, I’ve been running a 550sx with a KV total loss system for about a year and lost spark at the end of last season. I’ve replaced the coil and plug wires with brand new parts, I was wondering if anyone has any suggestions for what it could possibly be. I’m also searching for...

can bring to sff if paid in full Novi 48 dual carbs with arrestors- jetted for 800 Polaris with EME lay down pipe, freshly rebuilt with oem kits. Billet linkage and drum, proK filters. Might be a hair rich for a 701. Have had 3 sessions on them in freshwater only. I remember they had 2.0 n/s but...

I have the MSD Total Loss set-up on my Yamaha 760. It runs great on the trailer and when I first get going but once it gets hot it cuts out and then the ski stops running completely and unable to start again until cooled down. I cant seem to find troubleshooting tips for this problem. I am going...

Hi guys, I recently purchased a 2010 Rickter FS-2 with the intentions to upgrade the current 701 to a larger cc motor (Dasa 950, XS900, or a 781cc from Jet Maniac). Right now, the motor is pretty much stock. It's compression is around 183 per cylinder, b-pipe, and stock electronics. I'm...