The screen of mine is glued down right next to the drive shaft in the low flat area close to the bulkhead. Be sure to fuse the positive side. And the bilge hose runs out in front of the battery through the side. I run it with an aftermarket momentary switch that is apart of my start/stop switch.
use some JB WELD that thing will never come loose. just like dirtnut said take the screen off an glue it right next drives shaft, sense your putting one in you might as well put 2 in, better safe than sorry!!
when i got this ski it had the pump glued to the bottom by the drive shaft.
it came loose and the drive shaft chewed it up. so i was looking for something a little more solid.
there is a bracket i've seen on line that says it fits all the sx skis but to me it looked like there was not room for it. any one used one of these on a 750sx?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.