Blaster Reinforcement

sneds · Jan 3, 2016

I'm taking my Blaster to get reinforced. I planned on getting the bond line filled, 2 layers of 12oz biaxial on the sides (engine bay area). I also planned on about 5 layers of 12oz biaxial on the transom (stock it's just over 1mm thick). Anything else I should be doing or doing differently? Any feedback would be appreciated.

Sent from my C6906 using Tapatalk

Laleyenda · Jan 12, 2016

About the transom plate buy 701 transom plate looks good and does the job.

Wb1 rockered 900ss xscream

sneds · Jan 12, 2016

I've already cut open the rear tray and prepped the transom for reinforcement. Thanks though.

Sent from my C6906 using Tapatalk

Laleyenda · Jan 12, 2016

Go rockered Then

Wb1 rockered 900ss xscream

sneds · Jan 12, 2016

Actually, I gave rockered the front and rear a lot of thought but, I use my Blaster to take my kids out. I rode a rear rockered Blaster last summer and found it difficult to board. If we were to fall off, it would be nearly impossible to get back on.

Sent from my D6603 using Tapatalk

Laleyenda · Jan 12, 2016

The blaster aint Build for two persons

if you dont ride i hard and do Big bumps and so Then its not nessesary to reinforce anything

Wb1 rockered 900ss xscream

sneds · Jan 12, 2016

I don't always ride with my kids

Sent from my C6906 using Tapatalk

DamonB06 · Jan 12, 2016

Could you post up pictures of your reinforcement job? I have not seen much info on the toppic.

sneds · Jan 12, 2016

Sure, probably be a bit though

Sent from my D6603 using Tapatalk