FX-1 Fx1 pump mod looking for bearing yamaha housing kawi shaft

[gsxrking193]

I put a kawi 140 pump in my fx1 and was told that someone here had a thread about a bearing that would fit into the yamaha housing and accept a kawi zxi 900 shaft. Im new to the site and havent quite figured out how to navigate the site yet thanks for any help

 

[swapmeet]

I would start in the FX1 section cheif.

http://www.x-h2o.com/forumdisplay.php?136-FX-1

Lots of good info there. GL and welcome to the forum.

 

[gsxrking193]

I got it probly shouldve just looked a little harder lol but thanks. I bought 4 bearings and 4 seals just in case i need to make a backup

 

[Shadow7874]

4 Seals was a good idea but 4 bearings was way overkill.
Did you make sure you ordered seals with stainless springs?
There has been a decent amount of discussion on this lately in the fx1 section as im in the middle of the swap myself.
I would avoid my method of installation. Reinforce the pump shoe area from the backside with the tray cut ouy and it will be much easier then cutting it and reglassing it from the pump side like im doing.

 

[steve-uk]

heres what i did.... used the fx1 bearing housing, the bearing/seals from local bearing shop, 900zx1 shaft, 650 pump... job done

http://www.x-h2o.com/threads/54927-Steve-UK-FX-1-Build