How did I do with my Porting!?!

[2lick]

Give me some feedback + or - welcomed!

I modeled it after looking at some pictures and then looked at my cylinders..... I opened up the tops just a hair to match the base of the cylinder.....

Oh yeah I used the Watcon A-B Putty.. worked nice.. just took a while.... Glad i did because my porting did cut in to it... if that stuff falls out its not supposed to hurt it.... we will c....

Should I do anything Else???

-NICK

 

[2lick]

more

 

[jetskiking]

Those are weird looking cylinders:biggrin:

 

[jetskiking]

J/K when you first read it it sounds like you said you ported your cylinders and you didn't say cases in their once:biggthumpup:

 

[MADMAT]

I'm no expert but that looks really good to me. I have only had 1 set of ported cases though and I sold them cuz I didn't want to deal with re-epox again.

But mine had holes going in to the flywheel area.

 

[#ZERO]

Dude you went big on the porting, the width looks good but you went a little high on the roof area.

It will definitely flow a lot better than stock now.

If you have your cylinder lying around, install it with a couple of bolts and turn the case upside down to check the edges for proper blending.

 

[2lick]

Dude you went big on the porting, the width looks good but you went a little high on the roof area.

It will definitely flow a lot better than stock now.

If you have your cylinder lying around, install it with a couple of bolts and turn the case upside down to check the edges for proper blending.

I took care of that... i layed the cylinders on it and used that littel finger mirror in the picture... it was cool, i stole it off of some lipstick the the old womans purse.... crimps right on to the finger then i looked up and say the edges.. i sharpied them black to see the the lap better....

i to think they are a tad high... there not as high as they look, when i was done i kinda beveled the edges.. makes it look a lot bigger....

thanks for the feedback i think next time ill go a hair smaller... we will see how they run on my LPW cylinder!