Blaster How to test cdi, rectifier, coil, magneto?

R

redblaster007

Location
Cadilac, mi
Alright so as I posted a couple days ago my blaster died when I was balls out on it, pulled it to shore tested for spark and got nothing. Figured it would be kill switch but today I bipassed it and still got nothing so I think it's something a little deeper. I pulled the ebox but nothing LOOKS bad. Is there any way I can test the things mentioned in the title?
 
R

redblaster007

Location
Cadilac, mi
Thanks for the manual download, I'm on my phone and can't download it right now but does it tell in there what the ohms are supposed to be for everything, and if not is there like a list somewhere?
 
R

redblaster007

Location
Cadilac, mi
Aright so the tester I am using is "fluke" brand and its digital. It doesn't seem to be very specific on the readings and can be all over the place. Do I have to use the needle type?
 
#ZERO

#ZERO

Beach Bum
Location
Florida - U.S.A.
Either type meter will work and be sure the battery is good or your resistance readings could be all over the place as you mentioned. Also make sure your contact points are clean and free from corrosion. If you need any oem ground eyelets or terminals connectors with the waterproof boots I have plenty in stock with the prices in my picture gallery link.
 
R

redblaster007

Location
Cadilac, mi
Damn, I didn't think I even needed to have the battery hooked up to check ohms? Guess that might have been my problem on the readings. I checked all the connectors and grounds and everything appears to making contact just fine.
 
You must log in or register to reply here.
Top Bottom