I just completed the conversion to a rn using what sn parts would fit. I used the steering cable that came off my sn( whether or not it was the correct one is beyond me). The research I have done on here says They should interchange. I have adjusted it every which way but I still can't turn left. Turning right is excellent, but left lacks a quarter inch or so to fully turn. Any suggestions or links will be greatly appreciated.
Super Jet I can turn right, but barely left
- Thread starter Agee
- Start date
1. Disconnect the cable end from the steering plate knuckle.
2. Disconnect the cable end from the steering nozzle knuckle.
3. Center the cable. It should have approximately 3.5 inches of throw. Center it.
4. Adjust the cable ends on both the pump and pole side of the steering cable so that they fit their respective knuckles without moving the bars, the nozzle, or the cable.
2. Disconnect the cable end from the steering nozzle knuckle.
3. Center the cable. It should have approximately 3.5 inches of throw. Center it.
4. Adjust the cable ends on both the pump and pole side of the steering cable so that they fit their respective knuckles without moving the bars, the nozzle, or the cable.