Looking for a motor...

[18racing]

Need a motor for my X-2. I want at least a 750 with everything it needs to run in a x-2.........

 

[shawn_NJ]

I have a Groupk "sleeper" ported 760 big pin. Less then 4hours on topend and BRAND NEW hot rods crank was installed when the topend was done.

46SBN carb
Westcoast intake manifold
Groupk machined stock head
Stock Reeds
Reed stuffers
Cases tapped by Groupk for 650 stator

I paid $850 for the shortblock (no carb), then $1680 to GroupK for porting, rebuild, topend, ect. $400 for the crank, $250 for the 46SBN, $70 for the intake.
I have WELL over $3300 with shipping ect into the motor. It RIPS. I will sell it for $1250 for everything listed.

I also have a few FACTORY PIPES and COFFMAN PIPES if you want a complete package.

 

[18racing]

PM me your phone # shawn.

 

[shawn_NJ]

Sorry man. I was actually given an X2 hull yesterday and I think I'm going to drop the motor in that and make a bouy chaser.

 

[X2fanatic]

I have a cp watercraft 760 power boy motor. The only thing you would need is electronics a pipe and a carb if you are inteested in it. The motor has zero hours on it since it was built. I just had him build it about a month ago. there is actually a post about the motor. http://x-h2o.com/showthread.php?t=56355

 

[x2fatkid]

how much you want for the motor?

 

[X2fanatic]

I have about $1600 into it I would like to get around $1000 for it and I can also rumage up either some older 650 electronics or I have a 750 flywheel but I dont have the electrical box. It also comes with the stock carb but it would be a good idea to invest in a bigger carb