Msd total loss help

wikstromm

wikstromm

Washed up hillbilly
Location
SE
Hey! Any msd total loss ninjas that could help me with translate this settings?
In my opinion they seem kind of way to safe/low?
Sw 3
1 on, 2 on 3off 4off
5on 6on 7off 8on

Sw 2
1off 2off 3off 4off
5off 6on 7off 8off

Sw 1
1off 2on 3on 4on
5off 6on 7off 8on
 
wikstromm

wikstromm

Washed up hillbilly
Location
SE
Ah thanks!
Running a xs1000, rrp, dasa 48s, 155 skat sb
Flatwater
This is what i got from rick at xs so o guess i re set it at this when its ready

SWITCH 3
S1 S2 S3 S4 S5 S6 S7 S8
ON ______x_______ *_____________x____x
OFF _x________x___*_____x___x__________
5000 RPM 9250 RPM






SWITCH 2
S1 S2 S3 S4 S5 S6 S7 S8
ON ____________________x____x___x____x
OFF _x___x____x____x___________________




SWITCH 1
S1 S2 S3 S4 S5 S6 S7 S8
ON ______x____x____x_______x____x____x
OFF _x_________________x_______________
 
Last edited:
wikstromm

wikstromm

Washed up hillbilly
Location
SE
What do I do wrong?
Im trying to set static timing to 31* but I bottom out the adjusting holes in the stator already at 20*
 
wikstromm

wikstromm

Washed up hillbilly
Location
SE
Locating the tdc with an indicator in the sparkplug hole and a degreewheel on the flywheel bolt.
Tl set to Led function
 
Jcary85

Jcary85

Site Supporter
Location
Glenmoore pa
wikstromm said:
Locating the tdc with an indicator in the sparkplug hole and a degreewheel on the flywheel bolt.
Tl set to Led function
Click to expand...
Ok, then what? you need to then create a pointer of some type, then rotate the crank clockwise slowly until the light turns on. Whatever degree its at is your static timing.
 
wikstromm

wikstromm

Washed up hillbilly
Location
SE
Ofc i got a pointer, just got it, thanks for the help, i didnt get the right clearence for the pickups correct, the degrees were not consitent when I did mor testning
 
You must log in or register to reply here.
Top Bottom