Freestyle MSD total loss setup question

[Brian_216]

So today Im setting up my total loss. This is my first experience with it. I was wondering how picky they are? Im running all the wires neatly on the plate, bolting them down with the plastic wire retainers with fancy allen head screws and soldering/heat shrinking all my connections. Will using the electric drill method to twist the wires together cause any sort of interference? (I only did this for the 2 main wires from the brain to the battery) also running the power and ground wires from the brain, can they be near the coils? Sorry if all these have been asked before. Ill post a pic in a few.

thanks.

 

[Brian_216]

Here is a pic, once it's all fitted I will polish out the plate and make it look better.

 

[Waternut]

Only the old analog brains can't be mounted near the coil. The digital version are fine. I also don't see any problem with twisting any or all of the wires together. Mine are all clumped and zip tied together in a cris crossed mess and it doesn't seem to phase it. Just make sure the power wires are fused just in case they chafe together and short circuit.

 

[jdr8571]

I just made a plate for my coils and put my box with the battery just incase there is interference with the 2 being so close