Other RRP breather tube : McMaster number?

[Chris03HD]

Anyone have the McMaster Carr part number, for breather tubes for an RRP or similar pole?

EDIT : already tried my local Home Depot and Lowes.

Thanks

 

[hink320]

I don't think McMaster has them. I found mine at Home Depot.

 

[Mdavies_02]

The 2" Flex hose? I picked up at Depot in the HVAC section for $25.

 

[Chris03HD]

None of my Home Depots even have a 2" flex hose.. of any type.

 

[McDog]

Pretty sure rrp hose is 3 inches. No one seems to have it. I think it is the same size as whole house vacuum hose though but that stuff is expensive.

 

[Scorn800]

Go to a pool supply place and look at skimmer tubing

 

[ridetrp]

McMaster has is it. I'll dig up part # now and text it to you.
Incorrect. the sizing is very close to 2.5 od rrp tubes and holes in bracket aren't over 2.5 And Pool flex sucks

Sent from my SCH-I605 using Tapatalk 2

 

[tomski]

Flex hose 2.5" OD X 24", $22 each.

 

[McDog]

^^^^^That's the stuff.

 

[Chris03HD]

Flex hose 2.5" OD X 24", $22 each.


View attachment 245370

Link? Info?

 

[N3vrSat1sfied]

Or you can do what I did. A lot cleaner in my opinion then just a hose going thru the hull. 1.5" pool hose (amazon), and electrical conduit fittings (Home Depot)

 

[Chris03HD]

And that is enough air to feed your setup, or do you also have hood inlets too?

 

[N3vrSat1sfied]

And that is enough air to feed your setup, or do you also have hood inlets too?

Q8 has inlets on the back side of hood, like a kawi 750. I am running JM78BB, but I know another rider that had this setup with XM865 as well.

 

[zeski25]

http://www.thrustinnovations.com/store/index.php?main_page=product_info&cPath=32_36&products_id=357

 

[Proformance1]

Thrust for the WIN.

 

[THRUST]

Pretty sure rrp hose is 3 inches. No one seems to have it. I think it is the same size as whole house vacuum hose though but that stuff is expensive.

it is 2.25 house vacuum hose
but it is cheaper just to buy rrp unless you want 50'

 

[gto0209]

anyone have tips for getting the breather hose into the tubes? I had one pop out this summer.

 

[DAG]

Wd40 and twist it in. Work edges with flat head drive; careful not to poke hole in tube.