SOLD R&D Cylinder Lamey Cyl (needs repair)

[Nicotheskiguy]

R&D 7 port cast cylinder lamey cylinder
84mm flat top pistons (~2 hours on bore/pistons)
*Cylinder needs repair* Headbolt pulled and cracked around the insert
Comes with Dasa shelled head 28cc domes and hardware.

I’d fix it if I had the proper tools so I’m just cutting my losses.

$850 shipped? obo buyer pays fees
Located: North Georgia

 

[jacob06]

I'll take it! I'm in North Ga too, Cumming Ga

 

[waterfreak]

stock stroke or?

 

[Nicotheskiguy]

stock stroke or?

I can’t say for sure. I ran it with a 8mm crank using a 4mm spacer plate if my math is correct that would make it a stock stroke?

 

[Big Kahuna]

@Jr.

 

[waterfreak]

I can’t say for sure. I ran it with a 8mm crank using a 4mm spacer plate if my math is correct that would make it a stock stroke?

can you measure the deck height?

 

[Nicotheskiguy]

can you measure the deck height?

Is this what you’re referring to?

 

[MTRHEAD]

8mm cranks use mainly 133 rods (stock Kawasaki and/or Suzuki Tigershark)
Some billet Rad cranks used 132 Rad or 132 KTM. I also know of a couple that ran 135 GPR rods to run SXR pistons

What is needed is what is the total cylinder height. What is the exhaust height to top of cylinder and what is the transfer (highest) to top of cylinder then you will know what it was probably made for. Many many combinations possible given stroke,rods,piston heights.

 

[waterfreak]

Is this what you’re referring to?

No, the distance between the bottom of the cylinder and the top

 

[Nicotheskiguy]

No, the distance between the bottom of the cylinder and the top