Truzski

[fatboyktm]

OK I bought a head from him the head had two sets of domes but he did not know what cc they were, but one was race gas and I was told the other was (pump gas) All was good till I put the head on both sets are over 200 PSI that is not pump gas. I told him the head is no good to me. So I asked him to give me a call to make it right. I got a PM insted saying there was nothing wrong with the head and NO REFUND! This is not a stand up guy do not waste your money on him like I did. Thanks for reading. Shawn

 

[xXx Octane xXx]

I bought a Jetinetics Flywheel from him a few years ago that he claimed was in good condition (He removed it from his current running jetski). When I recieved it, the ring gear was chewed up and there were quite a few micro-cracks that propogated from the bolt holes on the hub to the kidney shaped holes in the face of the flywheel. After letting it sit on my shelf for over a year, I sent Robert at Jetinetics an e-mail with some pictures of the flywheel to get a quote to have the ring gear replaced. After he looked at the pictures he told me that it would be a waste of money to replace the ring gear because the flywheel was no longer in usable condition because of the cracks.

Given the amount of time that passed from the time I purchased it, I never bothered saying anything about it, at least not until now.

 

[Truzski]

xXx Octane xXx - Thats funny that you were trying to sell that flywheel about a year ago?? HMMMMMM???? So tell my why you were trying to sell it if it didnt work??

Fatboyktm- Thats also funny that the you dont mention a thing about the cylinder that I sold you?? Did that not work out either? Ohhh....hmmmm that must have been good?? There is nothing wrong with that head it was BRAND NEW!!

 

[fatboyktm]

cylinder

No realy I was going to let that be. But you sold that as a big bore 760 when it should have said 701 cylinder bored out past max bore to 84mm on a stock sleeve. All the people that have looked at it have said that the sleeves are soo thin that they would not run it. But I think that is my fault for not putting 84mm and big bore 760 together and not knowing that it could not be a 760 cylider. Like I said my bad.

 

[fatboyktm]

head

Yes the head is brand new thats not the problem and never was. The problem is a pump gas head does not make 210psi !!!! (Key words PUMP GAS) So now im out $80 + shipping to get the head cut so it will run PUMP GAS. We are beating a dead horse now, but what you did is wrong that is all. My last post on it Shawn

 

[xXx Octane xXx]

xXx Octane xXx - Thats funny that you were trying to sell that flywheel about a year ago?? HMMMMMM???? So tell my why you were trying to sell it if it didnt work??

Fatboyktm- Thats also funny that the you dont mention a thing about the cylinder that I sold you?? Did that not work out either? Ohhh....hmmmm that must have been good?? There is nothing wrong with that head it was BRAND NEW!!

At that particular point in time I was under the assumption that the flywheel was good, you know, just like you described it when you sold it to me.

After I talked to Robert I found out that the flywheel was no longer good for anything other than a paper weight. If I would have known that in the first place I would have never offered it for sale.