x2 Acc cable assistance.

Jayski

Jayski

Location
Australia Melbourne
Im fitting a new carbie on my x-2 and rather than the acc cable pulling from the top, it needs to pull from the bottom. what are my options.. Im running a westcoast manifold that has the facility for a cable... do i need to make or get a cable made?, i thought a 650sx one would be simular, but would be too long and i think it attaches to the bed plate anyway.
Assistance would be great.
 
Jayski

Jayski

Location
Australia Melbourne
dbrutherford said:
What type of carb? If it is a Mikuni SBN you just need a throttle drum/wheel and a throttle cable bracket. Hot Products carry these.
Click to expand...
Buckshot 46mm .. Yeah i understand but i figure it would be better comming from the bottom and using the manifold to pull off...


madscientist said:
the sx cable will fit but the top pull bracket and flipping the cable plate over will work just fine.

i run an sx cable in my x2 on the 750
Click to expand...

sorry dont quite get you there...
The 650sx cable will work, you use the sx pull bracket also?? flipping what around?? and you dont think its to long??
 
madscientist

madscientist

chilling with these guys.
Location
good old p'cola
the cable will run in to the nose and then back to the carb, or there is a bracket that bolts to the side of the carb on the 2 holes at the rim. you said buckshot? if so that will not work and bottom pull is your best option
 
You must log in or register to reply here.
Top Bottom