Search results

Is it done yet?

not me I will take a 4" hole saw to a $500,000 boat in a heart beat so drilling a 1" hole for a bilge thru hull in a ski will be easy! lol

Did you replace them when you rebuilt? What was in there before? I ordered a few different ones so I could play with pop off pressures.

That looks awesome!!! Doesnt lool like a lot of room for the e box with the front foot hold. How tight is it?

Forgive me if this has been said before but I have not read every post. Have you tried running directly from the tank to the carbs with new hose (Bypassing the fuel selector and filter)? Have you confirmed that the timing is correct?

Nice meeting everyone! Good times for sure. Dave

Had alot of fun that day here is my pic from the day. My Disclaimer: I have no disclaimer I'll rock my couch or superjet and if I could get on a blaster I'd rock that too. lol

you need just the shaft or the whole assembly?

carterB came through again!! parts were in great shape and shipping was quick. This is the second time dealing with him and very pleased again.

yamaha says .012 is acceptible but where is that measured from? I got .007 at the impeller and .022 just behind the splines. I'm rebuilding the midshaft bearing assembly and I dont want to wipe it out with a driveshaft that is out of spec. Thanks

I recieved everthing very quickly. Everthing was packaged well and all the parts were above and beyond what I expected. Looking forward to doing business again.

I ride the surf but mostly jump big boat wakes. Usually 40' to 50' range. The motor is a 701, b-pipe with ada head 185psi, nothing crazy but not stock. I plan on using trim too. I have a friend that has a very long ride plate and can get it across the good chop it I think it would kill his...

forgot to mention its a square nose if that matters

I weigh about 235 and I want a ride plate to improve stability at higher speed but I dont want to limit tricks such as a backflip. I jump mostly boat wakes so I need to be able to run boats down. I got a set of tubbies I need to put on also.

Thanks for the reply. yup 61X the only other thing I didn't mention is that the intake has been welded and ported a bit. Also where is a good place to get the parts for my carb?

what jets/settings should I be running? stock 701 B-pipe mod chamber ADA 35cc Head 46mm single carb

Thanks for the feedback guys I think the Red would look good but I'm going with black.

yeah pics would be cool. I only plan on doing the bottom of the tray and the rails and it will be covered when not riding.

How bad does red turf fade?

I can get you two part foam thats what I'm using. I'm on kent island.