Search results

Couldn't tell you what kind of grease, I purchased the motor pre-assembled. I will say when I removed the old seals, there wasn't a ton of grease in between the 2 rear seals.

Klotz SkiCraft, VP110 race fuel

Also to add, ski was running great and the rest of the crank appears spotless.

Hi all, I took apart my motor Dasa 1100 with 10mm crank due to a very slight front crank seal leak. While apart, I noticed what appears to be some light surface rust on the rear ball bearing cage. It looks worse in the picture due to the flash, as you can see if you zoom in the balls have zero...

I am listing my Aftermarket Gen 2 X2 for sale. It is ready to ride and in excellent condition. Very fast ski! The ski is registered/titled in Florida as a home-built vessel and is completely legit with an attached HIN number. I am located in NW Florida (Milton / Near Pensacola). Willing to...

Thank you!

I picked up an aftermarket gen 2 X2 with an SXR 800 engine with dual Mikuni SBN 44s. It also has a Factory B wet pipe. Does anybody have tuning specs for the above setup? Looking for main jet, pilot jet, n/s and spring, screw settings. Having a hard time finding that info for the dual 44s.

Not familiar can you give a more precise location?

Thank you I will send him a message!

I just recently moved to NW Florida (Milton). Is there any surf riding or riders anywhere near this area? Destin / FWB / Pensacola? I am willing to drive.

Anybody on here live in the panhandle of Florida (Santa Rosa County/Okaloosa/Pensacola area)? I am planning a move there in about a year. Good riding? Surf? Flatwater? Wanting to know the pros and cons of living there and what the riding is like. Thanks!

SOLD

TPE 1021cc, which to my understanding is the 964 with a +4mm stroke crank. Built by P&P Performance (Phil Clemmons) a couple of summers ago. It was completely rebuilt by P&P last summer and has barely been ridden since. I live at 5000 feet elevation, and have 2 sets of domes, for pump gas use...

Wet sand with 1000 then buff with compound, I followed this advice and it went away.

Wtf is this at Boyd? Were you flipping near the shore or did you go to where the boats are at?

I run new dasa 48s, and was told by my builder not to run return line jets as they are not needed with these carbs

Hull was sold this morning

The pending buyer is supposed to pick it up next weekend. I will update the thread if it falls through

PM'd

Looking for a new or very good condition used flatwater hull, particularly a full carbon tigercraft fvpro, also will consider dvx. Let me know what you have Thanks