Search results

Update!!!!!! Its hiding under a sheet of plastic, He needs a good swift kick in the ass for motivation!!!!

Go ahead make my day! Greet them with the 44. And rotweiler by my side. Then again Pa has the Castle doctrine http://en.wikipedia.org/wiki/Castle_doctrine I swear they threatened me and my family.

http://i1219.photobucket.com/albums/dd432/Joshuachollak/photo-4.jpg http://i1219.photobucket.com/albums/dd432/Joshuachollak/photo-5.jpg http://i1219.photobucket.com/albums/dd432/Joshuachollak/photo-6.jpg http://i1219.photobucket.com/albums/dd432/Joshuachollak/photo-7.jpg

Well it was a fun season on that setup but always room for improvement! With that said new line up of parts and mods for the next season have started to roll in and Major Surgery! MSD, mag pump and sitting and waiting ADA and single Mani with sbn I had but didn't swap at the end of the...

I figured there was some major cutting to get the nose that nice, you guys did a great job. It's clean n sleek the way they should have come.

Looks sweet, any more pics. I plan on flat decking mine but I am curious to see you build pics of the carbon work and cutting of the hull.

I've been workinng on the lag in the bottom on mine , I was running the duals Kraps off a 97 and have since picked up a SBN 46 with the single mani for it. After talking with the Rad dude guys about it lacking bottom. (install comming monday, with small pin cylinder), It has One hell of a top...

nice build, no go enjoy some surf

Prop Think I have 1 let me see

I picked up a SBN 46 Card and found a R&D mani (waiting on the arrival), Also decided to clean up my rear slightly washed cylinder and am putting a small pin cyl on it to boost the bottom. (better intake tract for bottom end). I know i said I was done and just riding till fall BUTT.... The...

SBN carb and ADA head are on their way. Need a intake manifole anyone have a 750 kaw single carb mani???

PUMP STUFFER/ SHIM AND SWIRL IN LAST NIGHT, made a big differance but still going to seek better bottom, along with a shaved head. Motor will have to wait for winter to get anything more. Just going to ride it the way it sits.

Blaster Factroy B pipe is a tight squeeze, Brian had to ding it a bit but she fits. The pipe and water box mod sounds sweet. Quiet at an idle and just right at WOT.

Took the first spin tonight, holy top end, needs a bit of low. Guess the big hub n stuffer will come in handy!! Time for prop trials!!! And replace some melted cooling lines. Oops! Gotba bit warm but if that's all that goes wrong for the first voyage I can live with that.

Got one

I'm guessing you have another your working on? other than the one in your signature.

There are two plates of stainless inside of the waterbox, You will need a long drill bit 1/2'' is the prefered by most. If you look in the bottom port of water box this is the one you must drill thru. Plan it out for anywhere from 4 to 7 holes evenly spaced (the more the better flow) do not...

Drill It , It is better to do than buy an aftermarket WB for it for the $$ and the Gain. You gain just as much power if not more and its isn't quite as loud. I drilled my last one and loved it and am planning on drilling my project's box tonight and I'm running a Factory B pipe with it.

Pump stuffer shim and Steering cable are in route!! Bars are G2G Got the Battery cables all to the correct length, tray is screwed down and the start stop finished up last night. Tonight Water Box Mod, Beer, and Dual cooling to be done posibly eliminate some slop in the steering stem.