Search results

Just looking for info or brands of starters. I only want to do this job once. AJS lists pro torque and wsm motors. They claim to be oem equivalent or better. Is there a go-to place for oem kawi parts ? Oh I already pm'ed JM but he usually doesn't deal w/ couch parts I only mention Atlantic...

Sounds more like a problem than complaint [emoji23][emoji23][emoji23][emoji23][emoji109]

So it's a factory factory dent

Good luck bro. Save urself. So glad I never indulged in nicotine that killer drug

Been down that road and million bits later.... Never again

@ least u didn't snap off an e z out

I shoulda left it to the experts , much more than I knew. Good info ^^^

Your ski is not hooked up to the surface of water , it's jumping in and out like a porpoise. Having a good pump seal and still water u should be locked , in a bay with chop it's not as easy

When your jet pump has a leak and is sucking air every time the ski jumps outta water- another term is porpoising

I'd say that's at least $500 overpriced. At least. Not sure of Washington market. Especially w/ a crack fiberglass I'd offer way less. On other hand prices go up ^^^ when spring / summer appear.

Jets ? Air/ fuel screws jiggy ?

Can't load my trivial complaint internationally - horrible wifi

Send this to carnage

Yep have place in surf city. We've used that inlet once to get to ocean down there. Mostly we ride in area by bridge but make occasional treks to beach haven to have a few @ sea shell[emoji482][emoji481]

Installed these $80 billet risers They bolt on easy. Only negative is its hard to get all 4 oem tight. Instructions say tighten all enough to move into position then crank down on the two accessible oem bolts. Nice height. I approve and so does my back. Before After

No problem here V. I bought them. I've lost way more. Confident the adjustables will work.

So I bought these for $30 But the hole spacing was too narrow by about 2-3 mm. Tried to ream holes but wasn't enough meat left to keep strength. I'm trying these next I'll report back

Props to Bren @ AGX he did mine as well

I'm working w/ atp brack and pole on rn. Wld like to c pics. Atp's dual bolt design is my issue

Nice job bro. Once you do 1( lookin that clean) you'll get the itch to work on others [emoji106]