Search results

If my motor didn't die I could have rode this one out. I think I'm still going too fast, I'm going to try to slow it down when I go out tomorrow. I'm so pumped I've made this much progression. Up until yesterday I only tried a few flips here and there and I was being a huge vag about it...

Just wondering if other guys with a short hull and a PowerFactor pipe have issues with water rushing into the exhaust and bogging the motor? It happens to me any time I do a power slide, especially when I slide to the left and the exhaust side is sliding out, also happens if I get some good air...

I just got my new flywheel in the mail and it looks like MSD has slightly modified it. They must have gotten some feedback about all the magnets falling off their flywheels and are trying to secure them better.

Ski was running perfectly fine until tonight, I rode it for about 10 min, just finished babying it to warm it up, when a boat went by. I hit their wake a couple times getting some decent air, after the third time I jumped it my ski started running like crap. I thought it had possibly ingested...

I rode my Footrocket today for the second time and everything was going great until about 20 minutes into it. I was just cruising on a plane and it shut off like I hit the kill switch and wouldn't start again. I determined there's no spark, so I pulled the Ebox and checked all my grounds and...

I'm trying to fix a 97 GP760 for a friend, I rebuilt the motor and it runs great, but now there's some kind of electrical problem. The ski will only let me hit the start button once and it will turn over and start, but if I stop the motor I have to disconnect the power and hook it back up...

I ordered a carbon Footrocket around September 2012 and after what felt like forever, it was in Canada in February 2013. I had to drive 6 hours each way to go pick it up from the closest international terminal which was in Winnipeg. Build list: - Krash Industries full carbon Footrocket -...

I bought a Jaz 3 gallon fuel cell for my build and I'm wondering why it seems nobody uses the bottom fittings on the tank for the feed? It seems everyone runs the pickup tubes on the top of the tank. Were people havig problems using the bottom fittings for the feed?

I'm about to install the pump shoe in my Footrocket and I just want to make sure I'm doing this right. My JD shoe had to be ground quite a bit to fit in the cavity, but I have it in there now. I'm wondering about the bonding process. You apply the adhesive to the bonding surface of the shoe...

I'm about to drill into my brand new Footrocket to install the hood latch and hood hooks and handlepole bracket...advice from people who have done this would be appreciated. What's the best way to figure out alignment of the latch so that it closes tight enough, but not too tight that I can't...

Sorry if this is a repost, not my hull, just stumbled upon it on ebay and it looks pretty sweet...

I bought a 97 waverunner 760 yesterday for cheap...I knew that it had a piston issue, but it was cheap and I haven't torn apart a Yamaha engine yet so I wanted to experiment on this before I tear down my xs865. Did a compression test before tear down and found 130psi in pto side cylinder, but...

I bought a Dasa 1200 with Full Spectrum carbs, PFP and MSD TL from Tricky1 and just received it in the mail today. I was pretty leery of sending that much money to someone off a forum that lives in a different country, but I can officially vouch for Tricky1 that he is definitely trustworthy...

I've been searching for a sticky or thread detailing how to install the pump shoe on a new a/m hull but can't find one anywhere? Does anyone know if there's a good write up on it? Thanks

I recently bought a Titan handlepole and Blowsion steering system from Mike @Optima, and he was great to deal with. Answered all my questions and gave me a great deal! Great customer service!

I'm looking for some suggestions on steering systems for my Footrocket. I like to run my steering a bit tight. I currently have xmetal non adjustable on my Matrix and I like it, but I have to tighten it every couple rides again and it's kind of annoying. The only other steering I've tried are...

So I have a footrocket on order that should arrive around December and I'm trying to decide on a powerplant. I only have a couple years riding experience, the first year on a 550, last year on a rn 701 with riva freeride pipe, and this year on a Trinity with ss865. I've pretty much narrowed it...

I have a line on a super cheap 96 waveraider, and I've done a search but can't find the info I'm after. I'm just wondering if many of the parts from the raider are transferable over to an SJ? Thanks

I just found one pretty close to me, I emailed the owner to try to find out more info, but all I know right now is that it's a WF backflip hull with an xscream motor. Has anyone rode one of these? How do you like them? Thanks

A friend of mine that works at a local powersports dealer informed me that they have an octane on consignment right now. Apparently its a polaris racing team edition with a 777cc motor, 2003. I was told you had to be on the polaris racing team to get one of these, so it's pretty rare. Only...