On the hydro turf, go ahead and spend the extra money by getting the kit that is already cut out for your ski. It makes a world of difference for the install because they are just about cut perfect with straight edges. As far as the DAP Weldwood Contact Cement goes, buy it from a hardware store...
Check your spark plugs to make sure their not fouling out. I would also check your compression to make sure the compression is good. High compression gives you more torque out of the hole. Your carburator might need to be adjusted too, sounds like it might be running rich and your putting too...
Your cheapest bet would probably be to check with an automotive dealer and see about using weather stripping for a car or even try lowes hardware / home depot. It might or might not work, but you could even cut your own groves in strippig so the hull edges will push inside rubber seal. You might...
I have a 92 SX 750, just rebuilt my top end (now bored to 80.50 mm) using SBT pistons and rings. I installed a ADA racing head using 28cc domes (should have my motor at 180 psi). Keep in mind my motor has NOT yet been ran with the top end. My compression right now is only 153 psi and 160 psi. Is...
I have used aerosal stripper to remove all the paint from my motor and I'm ready to repaint it but don't know the proper steps to use. Should I apply a high heat primer (spray can) and then use a high heat paint (spray can) or does it matter? Any help would be great, thanks.
I have used aerosal stripper to remove all the paint from my motor and I'm ready to repaint it but don't know the proper steps to use. Should I apply a high heat primer (spray can) and then use a high heat paint (spray can) or does it matter? Any help would be great, thanks.
I really appreciate it, I have everything ready to finish putting my motor back together but cant because SBT is closed thru the weekend and I'm hoping someone knows what to gap them at. Thanks again.
I'm rebuilding my 92 SX 750 with 80.55mm pistons and rings. Does anyone know what the ring gap needs to be when measured? This pistons and rings are both SBT. Thanks.
I'm rebuilding my 92 SX 750 with 80.55mm pistons and rings. Does anyone know what the ring gap needs to be when measured? This pistons and rings are both SBT. Thanks.
I'm rebuilding my 92 SX 750 with 80.55mm pistons and rings. Does anyone know what the ring gap needs to be when measured? This pistons and rings are both SBT. Thanks.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.