Finally getting ready to finish up my x2 build and I recently bought a factory b pipe and blaster chamber off guys from here obviously used and my chamber does not have a place to run a water line. Two of my buddys x2's do and of course mine doesnt.... should I run it or drill it out and weld...
so the outside was just about finished and i flipped it over to start sanding out the jb weld and some cracks in the bottom and re fiberglassed the weak parts and the nose.... check out this 650 motor
So Mr WillCastner and I decided to make a list of parts that I should put into this build to do it right so here it goes and this is what is going into the x2...
Its an 89 so we went with the rad dudes direct steer fix
surf brace by rad dudes
Rhaas Products motor mounts
small pin 750
pjs...
So here we go this is my first build with a lot of help from friends and a lot of time spent fixing this basket case of an x2 that I traded from a 650sx. Was told it was good to go and there was a 3 inch hole in the bottom of the case with zero compression... go figure.... so I did what anyone...
after lasts nights mishap:chairshot::chairshot::chairshot:i found something cheaper and more fun that we should get into.... I already have the pads and ill meet you at the dump later....http://www.youtube.com/watch?v=PBij58LQAhc
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.