Search results

Looking to sell my Xscream c5 engine, super clean engine used only for approximately 7 hours the engine was rebuilt in Xscream with Patrick and the engine runs great selling short block only, looking to sell for $8500 engine is located in united arab emirates and can ship world wide on buyers...

Hey guys, looking to sell my revolver pro series hull, super clean revolver pro series used countable times only, including handle pole with steering system and handle bar with also RRP footholds, hull has no scratches paint is in perfect condition looking to sell for $7500, it is located in...

Yes sir Sent from my iPhone using Tapatalk

The drive shaft is 07 shaft and impeller i have two one is 8/16 and one is 13/18 Sent from my iPhone using Tapatalk

Yes sir that was the problem from the low screws thank you Sent from my iPhone using Tapatalk

Those are 44’s and they on like 1/2 Sent from my iPhone using Tapatalk

Sent from my iPhone using Tapatalk

I mean the fuel lines,i checked the carbs they are tight and checked the intake it is tight and the gasket looks good and checked the fuel tank if it hold pressure inside it Sent from my iPhone using Tapatalk

This is only a one hour engine everything was good i only was trying to tune the carbs and didn’t tune them perfectly and left sitting in the workshop for while and now am trying to turn it on bu whenever it turns on it it stays for around two seconds and when i give it a little throttle it goes...

I can’t find any air leak not in the carbs not in the engine not in the tank not in the pipes so where can it be Sent from my iPhone using Tapatalk

Hi guys i need help whenever i turn my jetmaniac 781 on it gives full throttle i can’t find the problem, I can’t find any air leak in the carbs or in the tank or any pipe or anything can it be the tune or anything similar?

Yes sir i did try the torrent Sent from my iPhone using Tapatalk

This pump was custom from TJ and believe me better from the normal torrent 155 Sent from my iPhone using Tapatalk

Yes sir Sent from my iPhone using Tapatalk

I honestly do not know the ignition timing my mechanic is doing me the total loss cuz it’s a headache Sent from my iPhone using Tapatalk

I used to use pump gas 180 is a bit low if install the 200 psi dome thats totally better “my opinion “ and then u can just use pump gas cuz it’s not gonna be too high pressure so i think pump gas is gonna be fine Sent from my iPhone using Tapatalk

The piston blow and it blow off the crank rod bend and it made a crack on the case it was one hell of a blow man Sent from my iPhone using Tapatalk

Now it is just junk if u need it u could take it for $1000 but ur gonna have to rebuild it and buy a new case Sent from my iPhone using Tapatalk

Thanks guys am gonna try to rn Sent from my iPhone using Tapatalk

How much should i grind and what do u guys recommend grind the hull or the shoe