701

Ok so this summer I got into riding and I had a Kawasaki 650sx I’m selling that and next summer will be riding a Superjet my long term goal is be able to do a flat water backflip I know I will need to get an aftermarket hull what else will I need. Also can I put Superjet components into...

Ok so I want to buy a square nose Superjet and I found one for sale for 1800 it’s a 1994 it has foot holds and a bilge pump in it. It’s pretty clean inside and out is 1800 a good deal or should I keep looking

Ok so I was wondering if I were to get a square nose Superjet the 701 engine not 650 what would be the potential of it for freestyle I’m looking for more that what I could do on my 650sx. Or should I just skip the square nose and save my money to get a round nose

Ok so this guy is selling a 2004 Yamaha Superjet hull the only things it has are the hull pole and steering it’s has footholds and 0 or 4 degrees handlebars first question is how much would it be worth/ how much should I pay second question is what would be the estimated cost to build this thing...

Ok so I am new to the stand up game but this summer I bought a Kawasaki 650sx and I’m looking to upgrade for next year I’m interested more in the freestyle side of things and I was wondering if a Squarenose Superjet is even worth my time (the 701 ones not the 650s) or should I just save my money...

Hi there rider from the UK here, first question if anyone can help is: I run dual cooling on my ski (701 superjet B-pipe Etc) but 1 pisser is always spluttering out whilst the other is a constant stream of water even on throttle the bottom pisser barely has any water coming out of it? would a...

So i have a 96' rn superjet. I bought it from a guy about 5 hours away from me so i couldnt water test it. It runs great, but takes on water as you ride it. Sitting in the water not running it doesnt leak. It looks like the waters coming from the hull near the midshaft but its hard to tell...

i have a wdk RIP that I bought last week and now I'm having a few electrical issues. It's a 701 62t with a wdk manifold and pipe, ada girdled head, dual 44 carb, msd enhancer, and lightened flywheel. I had an issue with my battery dying every time I went out to ride, yesterday I went out without...

Hi everyone! I'm throwing the blaster back together and figured it is time to replace the grate. I have a two bar setup now. My ski is making a little more power than stock. It's a 61x with West coast wet jet intake and head. Im set up for around 180. 46mm wetjet mikuni carb. Ocean Pro...

Hey guys this is my first time posting on this forum and I'm in need of a little help. I picked up an Roundnose SJ for pretty cheap awhile back it has a 6m6 650 motor that was thrown in instead of the 701. Rode it for about a year now and I wanted more power so I picked up a dual carb 701 62T...

Hi guys, I recently purchased a 2010 Rickter FS-2 with the intentions to upgrade the current 701 to a larger cc motor (Dasa 950, XS900, or a 781cc from Jet Maniac). Right now, the motor is pretty much stock. It's compression is around 183 per cylinder, b-pipe, and stock electronics. I'm...

Hey all, Did a 701 swap on a buddies ski and took it out this weekend. Sad to say, the thing was not delivering the power it should. He said it best, it felt like the engine was "drunk." No carb tuning would help it run. The motor has a pretty dramatic vibration at idle, and under WOT it...

I have three parts for sale that would be a great addition to your Superjet. WILL SELL ALL AS A PACKAGE FOR $ 275 shipped. 1. Mikuni dual 44 mm carbs. No rust, primer only (no choke plates). $ 135 shipped 2. Pro Tec dual intake manifold for 44 mm carbs. Comes with reed cages. $150 shipped 3...

Hi everyone. I just moved from new jersey to st petersburg fl. Sold my ktm supermoto for a blaster but it turns out it has a bad wrist pin bearing and I just don't trust the crank (it sat for a while, half taken apart by the previous owner) The guy gave me his spare 62t/61x motor but its also...

Good Morning- I am currently in the process of building my first aftermarket hull and am very excited! I purchased a slightly used (10 mos. old) 2015 TigerCraft SV-1 from a friend and am changing out all of my old SN SJ parts and trying to do the best I can to build up a decent surf and boat...

Hey Guys, i don't think I've ever posted on the X. Im an 18 year old freerider from Australia. Been seeing some pretty cool pictures and videos come up in this thread from the US, so i though i would share some GoPro footage from a few weeks ago off the Sunshine Coast, Australia I captured off...