I flipped the trim nozzle segment 180 degrees so the brass actuator ball is on the top and Pulls to add up trim. With it flipped, it lines up perfectly with the top 'return' hole in the hull. I ran a bicycle brake cable through that hole into the engine bay and up the boot to a cheap bike brake lever on the handle bars.
I need to grind the steering nozzle half circle shaped part that is limiting throw still (see other thread) and I may have to grind the plastic actuator tab on the nozzle a little for even more throw.
These pics are just a mock-up so nothing is sealed or ready for the water. Any constructive comments or ideas would be appreciated. I know most people use that 'return' hole in the hull for dual cooling but if this works then I may remove the stock trim cable and use that hole for another cooling line on that side.
I need to grind the steering nozzle half circle shaped part that is limiting throw still (see other thread) and I may have to grind the plastic actuator tab on the nozzle a little for even more throw.
These pics are just a mock-up so nothing is sealed or ready for the water. Any constructive comments or ideas would be appreciated. I know most people use that 'return' hole in the hull for dual cooling but if this works then I may remove the stock trim cable and use that hole for another cooling line on that side.